Download Print this page

Mitsubishi Electric FR-F740-00023 Instruction Manual: Check First When You Have A Trouble; Motor Does Not Start

F700 series.
Hide thumbs

Advertisement

Check first when you have a trouble

5.5
Check first when you have a trouble
5.5.1

Motor does not start

Check
points
Appropriate power supply voltage is not applied.
(Operation panel display is not provided.)
Main
Circuit
Motor is not connected properly.
The jumper across P/+ and P1 is disconnected.
(01160 or less)
Start signal is not input.
Both the forward and reverse rotation start signals (STF,
STR) are input simultaneously.
Frequency command is zero.
(FWD or REV LED on the operation panel is flickering.)
AU signal is not ON when terminal 4 is used for
frequency setting.
(FWD or REV LED on the operation panel is flickering.)
Output stop signal (MRS) or reset signal (RES) is ON.
(FWD or REV LED on the operation panel is flickering.)
Input
Signal
CS signal is OFF when automatic restart after
instantaneous power failure function is selected (Pr. 57
"9999").
(FWD or REV LED on the operation panel is flickering. )
Jumper connector of sink - source is wrongly selected.
(FWD or REV LED on the operation panel is flickering.)
Voltage/current input switch is not correctly set for analog
input signal (0 to 5V/0 to 10V, 4 to 20mA).
(FWD or REV LED on the operation panel is flickering.)
was pressed.
(Operation panel indication is
Two-wire or three-wire type connection is wrong.
282
Possible Cause
(PS).)
Countermeasures
Power ON a moulded case circuit breaker (MCCB), an
earth leakage circuit breaker (ELB), or a magnetic
contactor (MC).
Check for the decreased input voltage, input phase loss,
and wiring.
If only the control power is ON when using a separate
power source for the control circuit, turn ON the main
circuit power.
Check the wiring between the inverter and the motor.
If commercial power supply-inverter switchover function
is active, check the wiring of the magnetic contactor
connected between the inverter and the motor.
Securely fit a jumper across P/+ and P1.
When using a DC reactor (FR-HEL), remove the jumper
across P/+ and P1, and then connect the DC reactor.
Check the start command source, and input a start
signal.
PU operation mode:
/
External operation mode : STF/STR signal
Turn ON only one of the forward and reverse rotation
start signals (STF or STR).
If STF and STR signals are turned ON simultaneously in
the initial setting, a stop command is given.
Check the frequency command source and enter a
frequency command.
Turn ON the AU signal.
Turning ON the AU signal activates terminal 4 input.
Turn MRS or RES signal OFF.
Inverter starts the operation with a given start command
and a frequency command after turning OFF MRS or
RES signal.
Before turning OFF, ensure the safety.
Turn ON the CS signal.
Restart operation is enabled when restart after
instantaneous power signal (CS) is ON.
Check that the control logic switchover jumper connector
is correctly installed.
If it is not installed correctly, input signal is not
recognized.
Set Pr. 73, Pr. 267, and a voltage/current input switch
correctly, then input an analog signal in accordance with
the setting.
During the External operation mode, check the method
of restarting from a
input stop from PU.
Check the connection.
Connect STOP signal when three-wire type is used.
Refer
to
page
——
20
14
14
177
22
177
155
136
136
25
22
272
114

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments: