Download  Print this page

Mitsubishi Electric FR-F740-00023 Instruction Manual: Parameter Verification

F700 series.
Hide thumbs

Advertisement

Parameter copy and parameter verification
appears...Why?
appears...Why?
and
Appears when parameters are copied between the inverter of 01160 or less and 01800 or more.
1. Set "0" in Pr. 160 User group read selection.
2. Set the following setting (initial value) in Pr. 989 Parameter copy alarm release.
Pr. 989 Setting
3. Reset Pr. 9, Pr. 30, Pr. 51, Pr. 52, Pr. 54, Pr. 56, Pr. 57, Pr. 70, Pr. 72, Pr. 80, Pr. 90, Pr. 158, Pr. 190 to Pr. 196, Pr. 557,
Pr. 893.

4.25.2 Parameter verification

Whether same parameter values are set in other inverters or not can be checked.
1.
Move the operation panel to the
inverter to be verified.
• Move it during a stop.
2.
Screen at powering on
The monitor display appears.
3.
Press
to choose the parameter
setting mode.
4.
Turn
until
appears.
5.
Press
value.
"
"(initial value) appears.
6.
Turn
to change it to the set value
" "(parameter copy verification mode).
7.
Press
of the verified inverter to the operation panel.
• If different parameters exist, different
parameter numbers and
• Hold down
8.
If there is no difference,
flicker to complete verification.
REMARKS
When the copy destination inverter is not the FR-F700 series, "model error (
flickers ... Why?
Set frequencies, etc. may be different. Check set frequencies.
264
Parameter read error. Perform operation from step 3 again.
Parameter write error. Perform operation from step 8 again.
flicker alternately
01160 or less
10
Operation
(parameter copy)
to read the present set
to read the parameter setting
flicker.
to verify.
and
Display
Flicker ··· Parameter verification complete!!
)" is displayed.
01800 or more
100
The parameter
number read
previously appears.
The frequency flickers
for about 30s
Flickering

Advertisement

Comments to this Manuals

Symbols: 0
Latest comments: