Setting from the parameter unit, operation panel
(2) Disable the setting dial and key operation of the operation panel (Press [MODE] long (2s))
Operation using the setting dial and key of the operation panel can be made invalid to prevent parameter change,
and unexpected start or frequency setting.
Set "10 or 11" in Pr. 161, then press
When the setting dial and key operation are invalid,
operation is attempted while dial and key operation are invalid,
touched for 2s, monitor display appears. )
To make the setting dial and key operation valid again, press
Even if the setting dial and key operation are disabled, the monitor display
4.22.3 Buzzer control (Pr. 990)
You can make the buzzer "beep" when you press key of the operation panel (FR-DU07) and parameter unit (FR-
PU buzzer control
The above parameters can be set when Pr. 160 User group read selection = "0". (Refer to page 173.)
The above parameters allow its setting to be changed during operation in any operation mode even if "0" (initial value) is set in Pr. 77 Parameter write
4.22.4 PU contrast adjustment (Pr. 991)
Contrast adjustment of the LCD of the parameter unit (FR-PU04/FR-PU07) can be performed.
Decreasing the setting value makes contrast light.
PU contrast adjustment
The above parameters are displayed as simple mode parameters only when the parameter unit (FR-PU04/FR-PU07) is connected.
When the operation panel is connected, they can be set only when Pr. 160 User group read selection = "0". (Refer to page 173.)
for 2s to make the setting dial and key operation invalid.
appears on the operation panel. If dial or key
0 to 63
appears (When dial or key is not
0 : Light