Advertisement
Advertisement
OPERATING INSTRUCTIONS PARTS LIST CRAFTSMAN JOINTER 4_/_ INCH Model Number 103.23340 This is the model number of your Jointer. It will be found on a plate located on the right side of the front table, Always mention this model number...
OPERATING INSTRUCTIONS PARTS LIST FOR MODEL NUMBER 103.23340 REAR TABLE SWINGING GUARD FENCE PROTRACTOR SCALE PROTRACTOR POINTER DEPTH OF CUT POINTER FENCE ANGLE DEPTH OF CUT SCALE FRONT TABLE HANDWHEEL FENCE LOCK HANDLE FIGURE INSTALLATION: units located under front table: upper lower slides,...
The fence lock handle is designed so that it may be honed occasionally with a fine abrasive stone to re- disengaged after use on the lock nut and will hang touch the edge. This operation be performed in a neutral position as shown.
ABRASIVE STONE FIGURE on the table as shown in fig. 2, tap the blades into the For the rabbeting operations, the fence is shifted cutter head with a piece of hardwood until the knife from its normal position at the right hand edge of edge just touches the straightedge...
attached after the front table position has begn estab- grain emerges on the surface of a piece wood. direction feed should governed lished, should rest rear table surface, accord:ngly; grain should emerge on the lower function of the fence in the beveling operation surface of the...
(210 29416 29204 fX330 29719 X627-- 18133 X2951 29421 29811 29718 Xll01 X516-_ 18716 X1403- X420 X176 18127 29715 29220 18711 29618' X210 X121 29422 29419 29423 29202 X2450 X547 18231 18437 .29722 29722 18516 x--29615 29717 29724 / _---X232 29109 ASSEMBLY FIGURE 29909-2--10-54---4,800...
Comments to this Manuals
Latest comments: