Download Print this page

CRAFTSMAN Gamefisher 298.585070 Owner's Manual

1.75 h.p..
Hide thumbs

Advertisement

i
: MODEL NO.
_298.585070
W
• 0 net s
responsibility
= mainlenance
• operation
• trouble
shooting
• replacement
parts
Publication No.
970.3535 ] -201
......... ...... : :i_• == i ' __i_ _:_=_i;!
=

Advertisement

   Related Manuals for CRAFTSMAN Gamefisher 298.585070

   Summary of Contents for CRAFTSMAN Gamefisher 298.585070

  • Page 1

    : MODEL NO. _298.585070 • 0 net s responsibility = mainlenance • operation • trouble shooting • replacement parts Publication No. 970.3535 ] -201 ....: :i_• == i ' __i_ _:_=_i;!

  • Page 2: Table Of Contents

    TABLE OF CONTENTS vase No: SPECIFICATIONS OWNER'S RESPONSIBILITY......•..MAINTENANCE ..LUBRICATION GEAR HOUSING .... : ..... MUFFLER INSPECTION ........PROLONGED STORAGE ... _ ....... OPERATIONS ...._ ......BOAT MOUNTING ........STEERING ADJUSTMENT ........2-CYCLE:ENGINE FUEL MIXTURE • STARTING PROCEDURES .,..

  • Page 3: Owner'sresponsibility

    ....iMPORTANT... -- ..Owner's Responsibility and Operating Safety Check List BE SURE TO READ DO THE FOLLOWING BEFORE OPERATING YOUR OUTBOARD MOTOR SAFETY CHECK LIST Learn and observe boating laws of the U.S, Coast Guard, state, iocat author_ ities. U.S.

  • Page 4

    MAJOR PARTS Fuel Fi!ler Cap and Air Ven[ Screw ChokeLevi Starlet Handle Power Heed Stop Bulton Spark Plug Fuel Shul-oll Valve ThrottleControlLever Reverse Driving Lock " • - Steerin_ Handle Fuel Sediment B owl and Filler Idenlificalion Plala Till Pin Adjustment Clamp StudHandles: Transom Bracket MufflerPipe...

  • Page 5: Maintenance

    MAINTENANCE 1. FEATURE INFORMATION MUFFLER INSPECTION a. This outboard motor special design Periodically remove muffler cover features as shown in Figur:e 1, screwing screws inspect carbon Your seJection of our Marine Products will build-up inside the muffler inlet and outlet, provide_you with many...

  • Page 6: Operations

    OPERATION BOAT MOUNTING Mount the motor on the center of the boat transom {stern). (See Figure 4), CAUTION Hand tighten clamp bracket clamp stud h0nd!_ _imuit0ne0u_ly, Do not use a wrench or any other device that would cause damage brackets, Occasionally check sure...

  • Page 7: Starting Procedures

    PERATION 2-CYCLE ENG4NE FUEL MIXTURE ;e a good grade of regular gasoline. (See mix. =table belowi)i _- _ ,CAUTION Always use BtA certified TC-W oil in the 50:1 ratio, Failure to dosomay result in excessive spark plug fouling, pistOn scoring, or bearing failure.

  • Page 8: Flooding

    OPERATION WARNING In case of an Emergency, the engine can be stopped by moving the Choke Lever to Fult Choke Position.. if the motor will be operated period of time, if it is to be removed from SLOW boat, if it is to be tilted up, we r_0rnm_nd the foll0wing practice to...

  • Page 9: Ignition System

    iPERATION 3• FLYWHEEL MAGNETO IGNITION SYSTEM The magneto ignition system consists of the following component parts: Contact Points, Condenser, Ignition Coil. (See Figure 13). Inspect the following engine fails or is hard to start: Spark plug as often as necessary. sure spark plug gap: setting is .025"...

  • Page 10: Trouble Shooting Check List

    TROUBLE SHOOTING CHECK LIST *Take your outboard motor into any one of over 2000 Sears Service Units, Fuel Tank Empty ' ... Fuel Shut-Off Valve Closed Fuel Line Kinked or Pinched Fuel Filter Dirty or Clogged Vent Screw on Fuel Tank Filter Cap Closed Carburetor...

  • Page 11: Replacement Parts

    REPLACEMENT_:PARTS :_ .._ ..-MODEL No. 298,585070...

  • Page 13: Spark Plug

    FIG. 1 ENGINE REF. PART NAME Q'ty PART CYLINDER SHROUD 1" 1 0 t6-01046-200 SPARK PLUG ASS'Y 1- 2 . 157-04000-900 018-00562-200 SPARK PLUG RCJ-8 " 002-01046-800 CYLINDER COMP 0 t 7-01000-203 CYLINDER GASKET 040-O1000-201 . PISTON RING/TOP PISTi3N RING/LOWER 04t-0i000-201 CLIP 039-01000.200...

  • Page 15

    FiG. ENGINE REF. PART PART NAME Q'ty 1-81 991-01060-027 992-10040-012 S. WASHER 1-91 1-92 991`01030-011 1-93 S. WASHER 992-10030-012 1-94 992-01030-011 WASHER SCREW,_X t0 1.95 990-11040-102 S. WASHER 1-96 992-i0040-042 1-150 985-35306-900 TOOL • • • L• i • •_ •,•...

  • Page 16

    "'1'1 44 43 42 "1"1 "IR I'1t...

  • Page 17

    F|G_2 :TANK & MUFFLER 3"t REF. PART PART NAME 756°00537-900 RECOIL STARTER ASS'Y 595-35100.902 TANK CAP ASS'Y 300-35306;200 ENGINE COVER 600-35! 00-203 TANK SUPPORT RING 401-35300-200 TANK '2-6 790-00601-202 STARTER PAWL SPRfNG 992-01050-011 WASHER 788-00601-203 STARTER PAWL STARTER PAWL SHIM 2.91 822-00601-200 793:10200-200...

  • Page 18

    "t'l "-4 "ri 5857...

  • Page 19

    FIG,2 TANK & MUFFLER PART REF. PART NAME Q'ty 2-64 992-10050-042 S. WASHER 2-65 990-11060-252 SCREW 6 x 25 2-66 992-10060-042 -S. WASHER 2-70 990-11060-! SCREW 6 x 12 992-10060-042 S. WASHER 2-71 2-72 SHEAR 012-35500-200 2-73 011-35100-200 cOTTER SIDE MARKRIGHT 2-!00 330-35351-200...

  • Page 20: Starter

    RECOIL STARTER PART NAME Q'ty PART RECOIL STARTER ASS'Y 3- 0-1 756-00537-900 772-00537-200 * RECOIL STARTER BODY * STARTER PULLEY 774-04015,204 * RECOIL SPRING 779-01006-201 776-01006_207 * PULLEY SHAFT * ROPE 783-00517-200 3-11 780-00801-201 * HANDLE GUIDE 785-10207-901 " STARTER HANDLE ASS'Y 3-12...

  • Page 21

    FIG:4 I¢ARBURETOR REF. PART PART NAME Q*ty 455-22907-90'1 4-0-1 CA R BU R ETO R -ASS'Y • * RUBBER CAP 560-22902-202 * CABLE ADJUSTER " • 597-22602-200 * BODYCAP '_'-: B9_22900-200 * THROTTLE VALVE SPRING 594-22602-200 " THROTTLE SPRING SEAT 619-22602-200 592-22907o9t0 * JET NEEDLE...

  • Page 22

    HANDLE & BRACKET...

  • Page 23

    FI G _!5:-HA NDLE:_::: :& B-RA¢ KET _:; REF. PART PART NAME 885-01046-800 THROTTLE WIRE COMP 870-00005-930 THROTTLE LEVER ASS'Y SCREW 5 x 25 990-I !050-252 991-01050-021 " JOINT PIPE HOLDER !45-35500-202 BOLT 8 x 40 990-21080-402 992-10080-042 S. WASHER 990-1 t050-202 SCREW 5 x 20 992-10050-042...

  • Page 24

    :iG.6 DRIVE SHAFT PIPE &iGEARI!jCASE 15"I 27 26...

  • Page 25

    FIG.6 DRIVE SHAFT PIPE & GEAR CASE REF. No. PART PART NAME Q'ty 6- 'I 090-35351 DRIVE SHAFT PiPE 075-35500 DRIVE SHAFT COMP 086-35500-200 BEARING HOLDER CL1P 999-62101-521 NEEDLE BEARING 1015 6- .5 039-35500-200 BEARING HOLDER 091-35500-200 DRIVE SHAFT PIPE GASKET 990-21080-402 BOLT 8 _ 40...

  • Page 26

    SERVICE MEMO J•,...

  • Page 27

    MODEL NO. 298.585070. For quick service or repair, take your Outboard Motor to any Sears Service Unit throughout FULL ONEYEARWARRANTYON U.S. and Canada, Each Service Unit is staffed OUTBOARD MOTOR trained technicians, using Sears approved For one year from Ihe t=rstday el use 0f parts and repair procedures...

Comments to this Manuals

Symbols: 0
Latest comments: