Download  Print this page

Craftsman 10 IN. TABLE SAW 315.22811 Owner's Manual: Maintenance; A. General Maintenance

10 in. table saw.
Hide thumbs

Advertisement

A. GENERAL
MAINTENANCE
0° BOLT
_,
WARNING:
Always begin by disconnecting
the
power supply.
Periodically check all clamps, nuts, bolts, screws,
and belts for tightness and condition. Make sure
the throat plate is in good condition and in position.
Check the blade guard assembly.
To maintain the table surfaces, fence, and rails,
periodically apply paste wax to them and buff to
provide smooth functioning. To prevent work from
slipping during cutting operation, Do not wax the
working face of the miter fence.
Protect the blade by cleaning out sawdust from
underneath the table and in the blade teeth. Use a
resin solvent on the blade teeth.
Clean plastic parts only with a soft damp cloth.
Do not use any aerosol or petroleum solvents,
B. SPECIFIC
TABLE
SAW MAINTENANCE
WARNING:
Always begin by disconnecting the
power supply.
TO SET BLADE AT 0 OR 45 DEGREES
The angle settings of your saw have been set at the
factory and, unless damaged in shipping, should not
require setting during assembly. After extensive use, it
may need to be checked.
Push the bevel locking lever to the right. See
Figure 48. Turn the blade adjusting handle to angle
the blade. Use a combination square to check
squareness between the blade and saw table.
If the blade is not perfectly
vertical (O degrees),
loosen the lock nut on the 0 degree bolt inside the
cabinet,
position the blade, adjust the bolt, then
retighten
lock nut. See Figure 48, insert. If the
bevel indicator
is not at zero, adjust it with the two
screws above the slot, beside the blade adjusting
handle.
Turn the blade adjusting
handle until the bottom of
the blade has moved completely
to the left side of
the slot. Lock the angle by pushing the bevel
locking lever to the left.
If the blade is not an exact 45 degrees,
loosen the
lock nut on the 45 degree bolt inside the cabinet,
position
the blade, adjust the bolt, then retighten
lock nut. See Figure 48, insert.
Make a test cut.
BEVEL
INDICATOR
45° BOLT
BEVEL
LOCKING LEVER
SCREWS
LOCKNUT
BLADE
ADJUSTING
HANDLE
0° BOLT
Figure 48
CRRFTSMBN"TABLESAW315.228110
34

Advertisement

   Related Manuals for Craftsman 10 IN. TABLE SAW 315.22811

This manual also for:

315.228110

Comments to this Manuals

Symbols: 0
Latest comments:
  • jim gibbons Apr 09, 2016 06:59:
    is there such a manual for the craftsman 10" table saw,i have looked everywhere to find manual and mitre gauge,anyo​ne got any info that can help me.