Download  Print this page

Craftsman 10 IN. TABLE SAW 315.22811 Owner's Manual: B. Settings And Adjustments; To Remove The Blade

10 in. table saw.
Hide thumbs

Advertisement

B. SETTINGS AND ADJUSTMENTS
TO REMOVE
THE BLADE
Use the two wrenches supplied with the saw for this
procedure
_l,
WARNING:
Unplug your saw and make sure
the blade guard assembly
is installed
and
working
properly
to avoid serious personal
injury.
Raise the blade guard. See figure 27, overview of
saw
Remove the three screws from the throat plate and
lift the throat plate out of the slot.
Push the bevel locking lever to the left for elevation
mode.
Raise the blade to its full height by turning the
blade adjusting handle clockwise.
Place the open end of the small hex wrench into
the slot beside the blade. The wrench will fit over
two flats on the arbor (blade shaft). See Figure 28.
Fit the large hex wrench onto the arbor nut. Turn
clockwise and remove the nut, taking care not to
drag your knuckles across the blade.
Note: The arbor nut has left-hand threads.
Remove the outer blade washer from the arbor and
then remove the blade. Make sure that inner blade
washer and both spacers are tight against arbor
shoulder.
Replace with a new blade. Make sure the blade
teeth are pointing forward, toward incoming work.
Put the outer blade washer and arbor nut back on,
aligning with the flats on the arbor. _ghten the nut
with a counterclockwise turn.
Note: Use care not to cross thread arbor nut. Do
not overtighten.
Rotate the blade by hand to make sure it is turning
freely.
Check the riving knife and adjust if needed (See
next procedure).
Insert the throat plate, lower the blade, then secure
the throat plate with the three throat plate screws.
Tighten the screws firmly.
Push bevel locking lever to the left to allow blade
elevation and lowering.
THROAT PLATE
BLADEGUARD
BEVEL
BLADE
LOCKING LEVER
ADJUSTING HANDLE
NOTE:PLACEBLADE BETWEEN
INNERANDOUTER BLADE WASHER
LARGE
RENCH
TO
LOOSEN
SMALL HEX
WRENCH
LARGESPACER
Figure 27
ARBOR
\
_h
ARBORNUT
TO ANGLEBLADE,
PUSHBEVELLOCKING
LEVERRIGHT,
_INNER
BLADE WASHER
OUTER
BLADEWASHER
,TO
TIGHTEN
Figure 28
TOLOWERBLADE, P USHBEVEL
LOCKING LEVERLIFTAND
ROTATE BLADEADJUSTING
HANDLE COUNTERCLOCKWISE
p#
#,l
TO RAISE BLADE, PUSH BEVEL
LOCKING LEVER LEFT AND
TO LOCK BLADE ANGLE,
ROTATE BLADE ADJUSTING
PUSH BEVEL LOCKING
HANDLE CLOCKWISE
LEVER LEFT
Figure 29
23
CRAFTSMAN"TABLESAW315.228110

Advertisement

   Related Manuals for Craftsman 10 IN. TABLE SAW 315.22811

   Related Content for Craftsman 10 IN. TABLE SAW 315.22811

This manual also for:

315.228110

Comments to this Manuals

Symbols: 0
Latest comments:
  • jim gibbons Apr 09, 2016 06:59:
    is there such a manual for the craftsman 10" table saw,i have looked everywhere to find manual and mitre gauge,anyo​ne got any info that can help me.