Download  Print this page

Craftsman 10 IN. TABLE SAW 315.22811 Owner's Manual: To Install Blade Guard; Operation

10 in. table saw.
Hide thumbs

Advertisement

TO INSTALL BLADE GUARD
[] To install the blade guard, first remove the three
screws holding the throat plate in place. Remove
the throat plate. See Figure 17.
Make sure that the locking lever is securely pushed
to the left. Raise the blade arbor to its full height by
turning the blade adjusting handle clockwise.
[] Move the locking lever to the right for Angle mode.
Slowly turn the blade adjustment handle to put the
blade at 30 degrees. The handle will "pop out"
slightly as it engages the clutch.
Holding the blade adjusting handle with one hand,
use the other hand to push the locking lever firmly
to the left to lock the angle.
Using Me smaU hex wrench, install the blade guard
by loosening the two attachment hex nuts enough
to slide the riving knife down between the shims.
Do not remove the hex nuts. See Figure 19.
Partially retighten the two attachment nuts. Check
the blade and riving knife alignment.
Correctly align the blade and riving knife as shown,
repeating step 5 as needed. Tighten attachment
nuts securely. If riving knife is not positioned
correctly, with blade up, it could contact saw table
when blade is lowered and restrict blade elevation.
[] Blade alignment with the riving knife can be
adiusted for different blade widths. Refer to
Settings and Adjustments in the Operations
Section.
[] Check the blade guard assembly for clearances
and free movement. Reinstall the throat plate into
the opening, lower the blade and secure the three
attachment screws. Tighten the screws securely.
SMALLHEX
Ir
LARGE
HEXWRENCH
THROAT PLATE
Figure 17
NOTE: PLACE BLADE BETWEEN
INNER AND OUTER BLADE WASHER
LARGE
SMALL HEX
HEXWRENCH
WRENCH_
LARGESPACER
ARBOR
\
ARBOR NUT
INNER
BLADE WASHER
OUTER
BLADE WASHER
,TO
TIGHTEN
Figure 18
RIVING
MOUNTING
PLATE
Figure t 9
CRmFTSMRN" TABLESAW315,228110
20

Advertisement

   Related Manuals for Craftsman 10 IN. TABLE SAW 315.22811

This manual also for:

315.228110

Comments to this Manuals

Symbols: 0
Latest comments:
  • jim gibbons Apr 09, 2016 06:59:
    is there such a manual for the craftsman 10" table saw,i have looked everywhere to find manual and mitre gauge,anyo​ne got any info that can help me.