Download  Print this page

Advertisement

19 electrolux safety
Use only properly grounded outlets.
Do not use an extension cord with
your water dispenser.
Always grasp plug and pull straight
out from outlet. Never unplug by
pulling on power cord.
Do not use dispenser if cord
becomes frayed or otherwise
damaged.
To protect against electric shock, do
not immerse cord, plug, or any
other part of dispenser in water or
other liquids.
Ensure dispenser is unplugged prior
to cleaning.
Position back of dispenser no closer
than 20cm from wall and permit free
airflow between wall and dispenser.
There must be at least 20cm
clearance on the sides of the
dispenser to permit airflow.
To avoid damage to the
machine,don't plug the power cord
or turn on the heating switch until
water runs out from the tap of hot
water.
Service should be performed only
by a certified technician.
Do not damage the refrigerant
circuit.
For indoor use only. Keep water
dispenser in a dry place away from
direct sunlight. Do not use
outdoors.
Never turn the machine upside down or
tilt it more than 45°.
This appliance is intended to be used
in household and similar applications,
such as: staff kitchen areas in shops,
offices and other working
environments; farm houses; by clients
in hotels, motels and other residential
type environments, bed and breakfast
type environments.
If the supply cord is damaged, it must
be replaced by a special cord or
assembly avaliable from the
manufacture or its service agent.
When the machine is under the ice
point and blocked by ice, the cooling
switch must be closed for 4 hours
before turning it on again to continue
its operation.
This machine should not be turned on
until 3 minutes later after turning off the
power switch.
Do not disassemble the electrical part of this appliance. Any repair done by
unauthorized person, can cause serious injuries or death.
In case of damage, please contact an authorized technical service agent.
safety electrolux 20
45º

Advertisement

Chapters

   Related Manuals for Electrolux EQB20C2MMS

Comments to this Manuals

Symbols: 0
Latest comments: